OK so you got some individually printed Resin Mini's, however one of them broke because it needed to rely on a very thin and small piece to keep it together. What are you going to do?
Well there's two options, firstly you can use as small drill and pin it together using part of a paper clip, which sadly I tried and it failed to take as it rebroke further up, and secondly you can do what I decided to do and make up some guts out of green stuff and have them hanging down the leg slightly to help sell the effect.
Ok its not very novel, but it does add a little extra flavour to your model and of course will look even cooler on the table. So what do you do? How do you save a model?
Ok its not very novel, but it does add a little extra flavour to your model and of course will look even cooler on the table. So what do you do? How do you save a model?
Thunder Mouser.
No comments:
Post a Comment